DHT-Walnut: JTAG Pin Out Connector Specifications for DHT-walnut-PPC405GP.be careful about what you do: you could damage the PCB To add the J10 to the board suck or wick the solder out of the holes and solder it in, but be minded a common header has pins larger than holes, so. See How To build the JTAG Wiggle interface & add the JTAG connector at J10, Just in case you make a brick, you could fix the jam, using this procedure: JTAG Bootloader Installation The OCD Commander software is supported under Windows 98/ME, NT, 2000, 2003, XP operating systems This debugger is not designed to be used to program flash devices connected to your target.

You will be able to test the connection, memory access, modify memory and registers, run code and more using this product. The OCD Commander is macraigor's free debugger software, which allows you to connect to your supported target type chip via the On-Chip Debug port (BDM or JTAG) using a Macraigor hardware device. 5 OCD, Recovering a bricked board (download and use the recovery kit).2.3 About the software for the jtag cable.JTAG cable for connection to a standard JTAG 20-pin 2.1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs.

JTAG/serial wire debug (SWD) specific features:.

SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector.

SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 Horizontal connector reference: 214012.

SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed.

SWIM low-speed and high-speed modes support.

1.65 V to 5.5 V application voltage support on the SWIM interface.USB 2.0 full-speed compatible interface.

Free download jtag pinout